Latest Boating Forum Topics:

  • Can Anyone take a Boat out to Sea? (9 posts)
  • boat moter not spitting water??? (4 posts)
  • Where to buy sail boats in vancouver? (2 posts)
  • How do I contact the marina vhf marine radio? (8 posts)
  • arkansas boating exam help? (3 posts)
  • Can my passengers drink on my boat in MI? (4 posts)
  • What waste tankers do southern water use? (3 posts)
  • 3 hp gamefisher outboard stops running after 1 or 2 minutes? (3 posts)
  • where do you find navigation charts for the columbia river? (4 posts)
  • Pirate dialogue. What sorts of insults might old fashioned pirates shout at each other while swashbuckling? (6 posts)
  • How do ships float? (10 posts)
  • Why wont my 90 hp outboard motor lower into the water, it is stuck in the up posion. The seliniod clicks.? (4 posts)
  • When did sailing start in the world and by who? (4 posts)
  • What has the "Queen of the Netherlands" (the ship) got to do with the Port Phillip Bay "Pilots"? (2 posts)
  • I am interested in purchasing a boat for around ,000 and I found one. BUT...? (3 posts)
  •  

    Boating Knots

    Rope, knots, and boating go hand in hand. Whether tying an anchor to a line or tying up a boat to a dock, the wrong knot will lead to trouble and the right knot, when properly tied, will hold under extremely heavy loads. We'll give you a few of the most common knots used in boating and do our best to tell you how to tie them.

    The two half hitch knot is a very reliable knot and used most often in mooring. Pass the end of a rope around a post or other object. Wrap the short end of the rope under and over the long part of the rope pushing the end down through the loop. This is a half hitch. Repeat on the long rope below the first half hitch and draw tight.

    The anchor bend knot is used in boating to tie the rope to the anchor. Start by passing two loops through a ring and then placing the free end around a standing line. Pass the free end through the loops on the ring. Complete by making a half hitch.

    The figure eight knot is ideal for keeping the end of a rope from running out of a tackle or pulley. Make an underhand loop bringing the end around and over the standing part. Pass the rope end under and then up through the loop. Draw tight.

    A clove hitch knot is a general utility hitch when boating for when you need a quick and simple method of fastening a rope around a post, spar, or stake. Begin by making a turn with the rope around the object and over itself. Take a second turn with the rope around the object. Pull the end up under the second turn so it is between the rope and the object. Tighten by pulling on both ends.

    When tied properly, the bowline knot won't slip or jam. This is a good tight boating knot. First, make an overhand loop with the end held toward you. Pass the end through the loop. Pass the end up behind the standing part and then down through the loop again. Draw tight.

    A sheet bend knot is used in boating to tie two ropes together. It is easy to tie, strong, secure, and works well with ropes of differing sizes. Make a loop in the end of one rope. If one line is heavier than the other, make the loop in it. Pass the end of the other rope through and around the loop. The working end should exit the knot on the same side as the loop's short ended side.

    Boating knots are important to learn for your safety on the water. When you know how to tie the basic boating knots, you will be safe and secure.

    Sponsored Links:

    Related Articles:

    Also In This Category:

    Currently Online :

    Search :

    No comments yet